84.3 kWm 1500 rev/min
97.6 kWm 1800 rev/min
Power Generation Application
1006TG1A
POWER PACK
■ High Power Density
The excellent combustion system can reduce fuel consumption, emission and noise, meanwhile increase engine power output.
■ Low Fuel Consumption
The excellent combustion system can reduce fuel consumption, emission and noise, meanwhile increase engine power output.
■ Easy Maintenance
All routine service items are situated on the right hand side of engine allowing easy maintenance and minimum machine downtime.
■ Durability & Reliability
Start normally at -1 o·c without preheated device, start smoothly at -25 °C through flame glow plug cold start aid. Maximum cooling efficiency is provided by a gear driven water pump and independent fan drive. Leak free operation is ensured by Viton crankshaft seals and sophisticated controlled swell joints, giving protection in the toughest conditions.
Standard Specification
Air inlet
Mounted air filter
Fuel system
In-line fuel injection pump
Spin-on full flow fuel filter and pre-filter
Lubrication system
Flat bottomed aluminum sump
Spin-on full flow oil filter
Oil cooler
Cooling system
Thermostat controlled cooling system with gear driven water pump
20″belt-driven pusher fan and guards
Electrical system
12 volt starter motor and alternator
Oil pressure and water temperature switch & sensor
12 volt shut down solenoid
Flywheel and housing
High inertia flywheel, size : 10/11 1/2
SAE3 flywheel housing
Mountings
Front engine mounting bracket
Optional Equipment
24 volt alternator
24 volt starter motor
Rear engine mountings
Workshop manual
General Data
Cylinder number 6 in-line
Cylinder arrangement Vertical, in-line
Borexstroke 100 mmx127 mm
Displacement 5.99 liters
Induction Turbocharged
Cycle 4-stroke
Combustion system Direct injection
Compression ratio 17.5: 1
Direction of Rotation Clockwise viewed from fan
Lub. System Capacity 16.1 liters
Coolant capacity(inc. radiator) 29.5 liters
Length 1484 mm
Width 740 mm
Height 1107 mm
net weight 710 kg
NOTE: Final weight and dimensions will depend on final specification.
